Access to this page has been denied because our system detected a potential security issue. If you’re a human and not a robot, don’t worry! Just check the box below to access the site:
What's the issue?
We’re dedicated to keeping SallyBeauty.com safe from bots and other malicious software. Sometimes a technical issue with your internet browser will trigger this response, such as:
Javascript is disabled or blocked by an extension (ad blockers for example)
Your browser does not support cookies
Check in your browser settings to make sure that javascript and cookies are enabled, and pause any ad blockers or other browser plugins. If you still run into problems browsing the site, please contact customer support and include the Reference ID number below in your message.
Access to this page has been denied because our system detected a potential security issue. If you’re a human and not a robot, don’t worry! Just check the box below to access the site:
What's the issue?
We’re dedicated to keeping SallyBeauty.com safe from bots and other malicious software. Sometimes a technical issue with your internet browser will trigger this response, such as:
Javascript is disabled or blocked by an extension (ad blockers for example)
Your browser does not support cookies
Check in your browser settings to make sure that javascript and cookies are enabled, and pause any ad blockers or other browser plugins. If you still run into problems browsing the site, please contact customer support and include the Reference ID number below in your message.
Using lash applicator, gently lift individual lash from tray.
Dip lash end into i-ENVY Lash Adhesive; do not saturate. (Both strip lash adhesive and individual lash adhesive can be used depending on how long you want your lashes to last. )
Place lash end as close to your natural lash line as possible. Repeat with additional lashes, until you achieve desired effect.
HOW TO REMOVE
Using eyelash adhesive remover or baby oil, moisten cotton swabs and gently massage over lashes. Lashes will loosen and fall off. Repeat the process for leftover adhesive residue if needed.