Nails: ABS Plastic
Glue: Bis-HEA PPG-6 Gylceryl Ether/SMDI Copolymer, Isobornyl Acrylate, HEMA, Trimethylbenzoyl Diphenylphosphine Oxide
Prep Pad: Isopropyl Alcohol, Water/Aqua/Eau

HOW TO USE  

STEP 1: PREP  

• Remove any polish before beginning nail prep.  
• Trim and file nails (white side of file).  
• Wash hands and use prep pad to clean & dehydrate nail beds.  
• Lightly buff nail beds (pink side of file).  
• Push back cuticles using wooden manicure stick.  

STEP 2: APPLY  

• Select nail tips for each nail. If in between sizes, size down or file a larger nail tip to fit.  
• Evenly spread a thin layer of soft gel glue to the bottom half of the pre-buffed (matte) section of the nail tip.  
• When applying to your nail, hold artificial nail between top of the nail tip and the number tab.   
• Apply nail tip from cuticle line to free edge to spread glue evenly, without releasing just yet.  

PRO TIP: If the glue does not fill the entire nail or if air bubbles have occurred, remove nail tip, apply more glue, and readjust.   

STEP 3: CURE  

• Keep pressure on the nail tip & cure under the GelXtend LED lamp for 60 seconds.*  
• To keep the light on, ensure your finger stays in contact with the sensor.   

*Lamp will automatically turn off after 60 seconds.  

PRO TIP: For opaque design nails, cure upside down for 60 seconds to ensure the light reaches glue.  

PRO TIP: Rotate the lamp as needed for an easier application process and tightly fasten the cap for the Max Comfort Super Gel Glue to prevent from drying out.  

HOW TO REMOVE  

STEP 1: Apply a drop of Dashing Diva Magic Off+ Remover at the cuticle line. Let product soak for at least 30 seconds.   

STEP 2: Starting at the cuticle line, use manicure stick or removing tool to gently separate artificial nail tip from natural nail. Add more remover as needed.  

PRO TIP: Do not use force to lift away at the nail. Use more remover and wait until nail lifts with ease.  

STEP 3: To keep nails healthy, buff nail surface using the pink side of the file. 

• For opaque design nails, cure upside down for 60 seconds to ensure the light reaches glue.  Make sure to prep your nails completely before application.
• If the glue does not fill the entire nail or if air bubbles have occurred, remove nail tip, apply more glue, and readjust.
• Avoid water for at least 1 hour after application.
• Don’t use any lotions or oils at least 2-3 hours before or after application.
• Apply nail tip at a 45 degree angle, starting from cuticle line to free edge