Nail Glue : Ethyl Cynoacrylate

Directions for Nail Application with ASP Builder Curing Gel

1.Shape nails, push back the cuticles and buff nails and dehydrate the nails.

2. Apply ASP™ Bonder on the entire natural nail.

3. Size the nail tips on all ten fingers so they are ready and waiting.

4. Buff the UNDERSIDE contact area of the nail tip to take the smooth shine away.

5. Apply a thin layer of ASP™ Nail Builder Curing Gel to the natural nail and cure for 10 sec in the LED lamp.

6. Apply ASP™ Nail Builder Curing Gel on the underside filed area of the full coverage tip and flip it and apply on the nails at a 45 degree angle to press out air bubbles, and press into place until gel fills up the natural nail. If possible, clean off any excess gel on the side of the nail.

7. Hold the tip in place, go under the light and continue to hold it for 10 seconds and then release and continue to cure for a full minute. It is important to hold the tip down initially as the light sets it into place before releasing and finishing the full cure.

Directions for application with nail glue

1. Prep nails by pushing cuticles back, dehydrate the nail plate and size the tips. Buff the underside of the nails tip for better adhesion.

2. To adhere the tip, apply a small amount of ASP™ Instant Nail Glue to the tip UNDERSIDE and press onto the nail.

Start by properly preparing nails by performing a mini manicure

Buff the UNDERSIDE contact area of the nail tip to take the smooth shine away, helps adhesion.

Works Great with ASP Brush On Curing Builder Gel