Polish:

1. Apply a thin coat of China Glaze Gelaze polish color to each nail bed and free edge on all four fingers on one hand. NOTE: gel polish will remain tacky even after curing process and until nails have been cleaned. Apply in the center of the nail, starting at the cuticle moving to the edge of the nail. Cap the free edge for longer wear. If gel polish touches the cuticle, remove prior to curing by using the edge of the cuticle pusher.

2. Cure all four finger nails for 30 seconds in an LED lamp.

3. Repeat the process on the other hand and for thumb application.

4. Repeat steps 1-3 for a second coat. NOTE: First color coat may be semi-sheer.

Top Coat:

1. Apply a thin layer of China Glaze Gelaze top coat to each nail bed and free edge on all four fingers on one hand. NOTE: Top Coat will remain tacky even after curing process and until nails have been cleaned. NOTE: Apply in the center of the nail, starting at the cuticle moving to the edge of the nail. Cap the free edge for longer wear. If Gel Top Coat touches the cuticle, remove prior to curing by using the edge of the cuticle pusher.

2. Cure all four finger nails for 30 seconds in an LED lamp.

3. Repeat the process on the other hand and for thumb application.

4. Proceed to Cleanse Step to remove tacky residue for a shiny finish.

Cleanse:

1. Saturate a nail wipe with Gel Cleanser.

2. With light pressure swipe the nail wipe over the nail to remove tacky gel surface. IMPORTANT: Use the clean side of nail wipe for each nail to prevent dulling of the Gel Top Coat.

Removal:

Using a nail file, gently file the surface of gel nail to break the seal and remove shine. Saturate pad on Gel Remover Foil Wrap with Gel Remover. Place saturated pad on top of gel nail. Wrap foil around the finger and secure. Allow to penetrate for 10 minutes. Use a cuticle pusher to gently loosen and remove gel. If necessary, buff off remaining gel with buffing block.