Before you apply the Caps and Foam over your nail tip, remove the shine from the gel color with a 180 grit file. This will help speed up the removal process.

 

1. Put a small amount of Soak Off solution on rounded end of removal pad.

 

2. Insert foam pad (rounded side first) into the custom cap. Some foam should still be sticking out of the custom cap (This is important as it acts as a barrier to prevent acetone from seeping out).

 

3. Slide finger into cap with foam side on the nail and soak for necessary time (8-10 min).

 

Do not overload the pad with Soak Off solution. Too much will only cause it to leak out of the caps.

 

For a time saver, a tech can prepare all 10 caps + foams prior to the customer’s arrival and apply the Caps and Foams to all 10 fingers at once.

Pump a small amount of Soak off solution on pad, insert foam pad into cap leaving some foam sticking out, this will help the acetone not to leak. Slide finger into cap with nail bed to the foam pad for the necessary time. Do not overload the foam with acetone as this will cause leaking.